Back to Contents Page

RF Module

Dell™ XPS One™ Service Manual

Part to remove: RF Module

Pre-removal steps: During installation or removal of any hardware, always turn off the computer and ensure that all data is backed up properly. Disconnect any telephone, network, and USB cables from the computer. Disconnect the computer and all attached devices from their electrical outlets. Remove the computer cover. Remove the BCAS assembly. Whenever opening the computer, lay it flat with the LCD facing down on a soft towel or surface that will not scratch the glass face. The foam inserts from the computer packaging can be used to protect the glass face of the LCD. A cleaning/wipe cloth was included with the computer originally that can be used for this purpose.

1. Remove the single screw securing the RF module.

2. Flip the RF module over the access the RF module cable. Please be careful with the RF Module cable; there is very little slack in the cable and it can easily be damaged if excessive force is applied.

3. Disconnect the RF module cable.

4. Remove the RF module.

Back to Contents Page