NOTE: If you ordered the optional Mini-Card at the same time that you ordered your computer, the card
is already installed.
Removing the Mini-Card
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface, such as the back panel on the computer.
Loosen the two captive screws on the modem/Mini-Card/wireless cover, then remove the cover
and set it aside.
1
modem/Mini-Card/wireless cover
2
captive screws (2)
Disconnect the antenna cables from the Mini-Card.
1
antenna cables
NOTICE: To prevent damage to the Mini-Card connector, do not use tools of any kind to spread the metal clips that
secure the Mini-Card.
Use your fingertips to carefully push back on the metal clips securing each side of the Mini-Card until
the card pops up.
1
Mini-Card
2
metal retention clips (2)
Remove the Mini-Card from the connector at a 45-degree angle.
Replacing the Mini-Card
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface, such as the back panel on the computer.
NOTICE: To avoid damaging the Mini-Card, make sure the antenna cables are not under the card when you
secure the card into place.
NOTICE: The edge connector is keyed to ensure correct insertion. If you feel resistance, check the connector and
realign the card.
Install the new Mini-Card:
Align the notch in the Mini-Card edge connector with the tab in the connector slot.
Slide the Mini-Card firmly into the slot at a 45-degree angle, and then rotate the card down until
it clicks into place. If you do not feel the click, remove the card and reinstall it.
1
Mini-Card
Connect the antenna cables to the Mini-Card. Make certain that the cable connectors snap securely
into place.
1
antenna cables
Replace the modem/Mini-Card/wireless cover and tighten the screws.
