Back to Contents Page

Camera Module

Dell™ Inspiron™ 1420/Dell Vostro™ 1400 Service Manual

  Removing and Replacing the Camera Module

Removing and Replacing the Camera Module

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as the back panel on the computer.

1. Follow the instructions in Before You Begin.
   
   
2. Remove the display bezel (see Removing the Display Bezel).
   
   
3. Lift the cable securing tab and gently pull the camera module cable from the connector.
   
   
4. Remove the two M2 x 3-mm screws securing camera module to the display assembly.
   
   
5. Gently lift the camera module.
   
   
6. Install the replacement camera and tighten the two M2 x 3-mm screws.
   
   
7. Insert the camera module cable in the connector and press down the securing tab.
   
   
8. Replace the display bezel (see Replacing the Display Bezel).
   
   

1	display	2	screws (2)
3	camera	4	camera module

Back to Contents Page