Manuals

System Power-Supply Removal (Mini Tower): Dell Precision™ WorkStation 210 Systems

1. Disconnect the AC power cable from the back of the power supply.
2. Free the system power supply from the securing tab labeled "RELEASE -->," and rotate it upward until it locks.
   Press the securing tab to release the power supply.
3. Disconnect the DC power cables from the system board and the drives.
   Note the routing of the DC power cables underneath the tabs in the chassis as you remove them from the system board and drives. It is important to route these cables properly when you replace them to prevent them from being pinched or crimped.
4. Facing the left side of the computer, move the front end of the system power supply toward you, and lift it to disengage the system power supply from the slot in the chassis.
5. Lift the system power supply from the computer.

When you reinstall the power supply, place the power-supply detent link over the pin on the power supply as you position the power supply in the chassis opening.