Manuals

Computer Cover Removal (Mini Tower): Dell Precision™ WorkStation 210 Systems

1. Remove the padlock from the padlock ring on the back panel of the computer, if one is installed.
2. Facing the left side of the computer, press the release button at the bottom-left corner of the front bezel.
3. Lift the bottom of the cover, allowing it to pivot up toward you.
4. Disengage the tabs that secure the cover to the top of the chassis, and lift the cover away.

Before you reinstall the cover, fold all cables out of the way so that they do not interfere with the cover or with the proper airflow inside the computer.

When you boot the system, you will need to reset the chassis intrusion detector by entering the System Setup program and changing the Chassis Intrusion setting to Not Detected. For more information, see Chapter 3, “Using the System Setup Program,” in the User’s Guide.

NOTE: After removing and replacing the cover, the chassis intrusion detector will cause the following message to be displayed at the next system start-up: ALERT! Cover was previously removed. If a setup password has been assigned by someone else, contact the network administrator for information on resetting the chassis intrusion detector.