Computer Cover Removal (Desktop): Dell Precision WorkStation 210 Systems
Computer Cover Removal (Desktop): Dell Precision™ WorkStation 210 Systems
- Remove the padlock from the padlock ring on the back panel of the computer, if one is
installed.
- Facing the front of the computer, press in the two release buttons (located on the sides
of the cover toward the back).
- While still pressing the two release buttons, lift the cover at the back, allowing it to
pivot up toward you.
- Disengage the plastic hooks that secure the cover to the front of the chassis, and lift
the cover away.
Before you reinstall the cover, fold all cables out of the way so that they do not
interfere with the cover or with the proper airflow inside the computer.
When you boot the system, you will need to reset the chassis intrusion detector by
entering the System Setup program and changing the Chassis Intrusion setting
to Not Detected. For more information, see Chapter 3, “Using the
System Setup Program,” in the User’s Guide.
 |
NOTE: After removing and replacing the cover, the chassis intrusion
detector will cause the following message to be displayed at the next system start-up: ALERT! Cover was previously removed.
If a setup password has been assigned by someone else, contact the network
administrator for information on resetting the chassis intrusion detector. |
|
