Manuals

System Board Removal (Mini Tower): Dell Precision™ WorkStation 210 Systems

1. Place the computer on its side on a flat surface.
2. Unlatch and rotate the power supply until it stops.
3. Disconnect all cables from their connectors at the back of the computer.
4. Disconnect all cables from the system board.
5. Remove the microprocessor fan.
6. Remove the screw that secures the system board to the side of the chassis.
7. Slide the system board toward the front of the chassis until it stops.
8. Carefully lift the system board out of the chassis (be sure to lift evenly and not twist the system board).

If you are replacing a system board, remove the DIMMs, the primary microprocessor SEC cartridge/heat sink assembly, and the terminator card or secondary microprocessor assembly, and install them on the replacement board.

When you reinstall the system board, before you slide the system board back to lock it in position, push down near each slot to engage the grounding clip onto its corresponding tab. Push evenly on both sides of the system board as you slide it into position (do not twist the system board).