Back to Contents Page

About Your Monitor

Dell™ M993s Color Monitor User's Guide

  Front View

  Back View

  Side View

  Bottom View

  Monitor Specifications

Front View

Back View

Side View

Bottom View

Monitor Specifications

Power Management Modes

If you have VESA's DPMS compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. This is referred to as 'Power Save Mode'*. If input from keyboard, mouse or other input devices is detected by the computer, the monitor will automatically 'wake up'. The following table shows the power consumption and signaling of this automatic power saving feature:

* Zero power consumption in OFF mode can only be achieved by disconnecting the main cable from the monitor.

Pin Assignments

15-pin D-Sub connector:

Plug and Play Capability

You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. If desired, you can select different settings, but in most cases monitor installation is automatic.

General
Model number	M993s
CRT (19")
Screen dimensions
Preset Image Size (This is the Dell-recommended viewing image)	Diagonal 17.32 inches(440 mm) Horizontal 13.86 ± 0.16 inches(352 ± 4 mm) Vertical 10.39 ± 0.16 inches(264 ± 4 mm)
Viewable Image Size (VIS) (This is the maximum viewable image)	Diagonal 18.00 inches(457.2mm) Max Horizontal 14.37 inches(365 mm) Vertical 10.79 inches(274 mm)
Dot Pitch	0.236 mm
Deflection angle	90°
Phosphor type	P22 (R,G,B, medium short persistence)
Faceplate coating	Anti-static/anti-glare non-diffusing, multi-layer coating, high gloss value (spin coating)
Resolution
Horizontal scan range	30 kHz to 96 kHz (automatic)
Vertical scan range	50 Hz to 160 Hz (automatic)
Optimal preset resolution	1280 x 1024 at 75 Hz
Highest preset resolution	1600 x 1200 at 75 Hz
Highest addressable resolution	1600 x 1200 at 75 Hz
NOTE: Dell does not guarantee image performance on non-preset video modes.
NOTE: Dell guarantees image size and centering for all preset modes listed in the following table.
Supported Resolutions Display Mode Horizontal Frequency (kHz) Vertical Frequency (Hz) Pixel Clock (MHz) Sync Polarity (Horizontal / Vertical) IBM®, VGA2, 720 x 400 31.469 70.087 28.322 -/+ IBM, VGA3, 640 x 480 31.469 59.940 25.175 -/- VESA, 640 x 480 43.269 85.080 36.000 -/- VESA, 800 x 600 53.674 85.061 56.250 +/+ VESA, 1024 x 768 68.677 84.997 94.500 +/+ VESA, 1280 x 1024 79.976 75.000 135.00 +/+ VESA, 1280 x 1024 91.15 85.000 157.50 +/+ VESA, 1600 x 1200 93.750 75.000 202.50 +/+
Electrical
Video input signals	Analog, 0.7 Vpp, positive at 75 ohm
Synchronization input signals	Separate horizontal and vertical; TTL level, positive or negative
AC input voltage / frequency / current	90 to 264 VAC / 50 or 60 Hz ±3 Hz / 2.0 A (RMS) at 120 VAC and 1.0 A (RMS) at 220 VAC
Inrush current at 120 V	20 A
Inrush current at 220 V	35 A
Physical Characteristics
Connector type	15-pin D-subminiature
Signal cable type	Attached to monitor
Dimensions:
Height (with base)	17.7 inch (450 mm)
Height (without base)	15.7 inch (400 mm)
Width	17.3 inch (440 mm)
Depth	18.3 inch (464 mm)
Weight (monitor only)	46.2 lb (21 kg)
Weight (with packaging)	53.4 lb (24.25 kg)
Environmental
Temperature:
Operating	32° to 104 °F (0° to 40 °C)
Non-operating	-4° to 140 °F (-20° to 60 °C)
Humidity:
Operating	5% to 90% (non-condensing)
Non-operating	5% to 90% (non-condensing)
Altitude:
Operating	3,000 m (10,000 ft)
Non-operating	10,668 m (35,000 ft)
Thermal dissipation	341 BTU/hour (maximum) 290 BTU/hour (typical)

Back to Contents Page