DTA: Jumpers/Switches/Controls
Jumpers/Switches/Controls
Jumpers
Switches
Controls
Jumpers
System Board Layout
 = pins 1-2 jumpered
 = pins 2-3 jumpered
Red dot notes pin 1
75-90  75/50-MHz processor installed.
75/90  90/60-MHz processor installed.
75/90  100/66-MHz processor installed.
ENA/DIS PSWD  (default) The password feature is enabled.
 The password feature is disabled.
M/C  (default) Color monitor installed.
 Monochrome monitor installed.
NRM/CLR  (default) System setup settings are retained at next
system boot.
 System setup settings are cleared at next
system boot.
FLASH RCVR/NRM  (default) Reserved. Do not change.
SU  (default) Allows the user to enter the system setup
program.
 Prevents the user from entering the system
setup program.
NRM/WP  (default) Flash BIOS is not write-protected.
 Flash BIOS is write-protected.
Switches
There are no internal switches in this system.
Controls
Front Panel Controls/Indicators
Power Switch
The power switch is a push-button on/off switch.
Power Indicator
The power indicator lights up when the system unit is on.
Reset Button
Pressing the reset button initiates a hardware reset. To avoid possible data or file structure corruption, use the reset button only when the system cannot be rebooted with the <CTRL-ALT-DEL> key combination, and close any open applications or files if possible.
Hard-Disk Drive Access Indicator
The hard-disk drive access indicator lights up when the hard-disk drive is being accessed.
Diskette-Drive Access Indicators
The diskette-drive access indicators light up when the diskette-drive is being accessed.
| 