Back to Contents Page

System Board

Dell™ XPS™ M1530 Service Manual

  Removing the System Board

  Replacing the System Board

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the computer. The replacement kit for the system board includes a CD that provides a utility for transferring the Service Tag to the replacement system board.

NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.

Removing the System Board

1. Follow the instructions in Before You Begin.
   
   
2. Remove any installed ExpressCards from the ExpressCard slot.
   
   
3. Remove any installed memory modules or Mini Cards (see Memory and Communication Cards).
   
   
4. Remove the hard drive (see Removing the Hard Drive).
   
   
5. Remove the internal card with Bluetooth® wireless technology (see Removing the Card).
   
   
6. Remove the display assembly (see Removing the Display Assembly).
   
   
7. Remove the palm rest (see Removing the Palm Rest).
   
   
8. Remove the optical drive (see Removing the Optical Drive).
   
   
9. Remove the ExpressCard reader (see Removing the ExpressCard Reader).
   
   
10. Remove the wireless sniffer board (see Removing the Wireless Sniffer Board).
    
    
11. Disconnect the button board cable from the system board connector (see Removing the Button Board).
    
    
12. Disconnect the speaker cable from the system board (see Removing the Speaker).
    
    
13. Remove the three remaining M2.5 x 5-mm screws that secure the system board to the computer base.
    
    

14. Lift the system board at an angle toward the side of the computer and out of the computer base.
    
    

Replacing the System Board

1. Follow all of the steps in Removing the System Board in reverse order.
   
   

NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

2. Turn on the computer.
   
   

NOTE: After you have replaced the system board, enter the computer Service Tag into the BIOS of the replacement system board.

3. Insert the CD that accompanied the replacement system board into the appropriate drive. Follow the instructions that appear on the screen.
   
   

Back to Contents Page