Back to Contents Page

Wireless Sniffer Board

Dell™ XPS™ M1330 Service Manual

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.

1. Follow the instructions in Before You Begin.
   
   
2. Remove any installed ExpressCards from the ExpressCard slot.
   
   
3. Remove the palm rest (see Palm Rest).
   
   
4. Remove the express card cage (see ExpressCard Reader
   
   
5. Disconnect the wireless sniffer board cable from the system board.
   
   
6. Remove the two M2 x 3-mm screws from each side of the sniffer board and remove it from the computer base.
   
   

1

wireless sniffer board cable connector

2

M2 x3-mm screws (2)

3

wireless sniffer board

Back to Contents Page