NOTICE: Note the location and ID of each power connector before disconnecting the power supply cables.
Follow the DC power cables that stem from the power supply and
disconnect each connected power cable.
NOTE: Note the routing of the power cable bundles as you disconnect them. You must route these cables properly when you replace them to prevent them from being pinched or crimped.
Remove the four screws that secure the power supply to the back of the
chassis.
Remove the screw that secures the power supply cable clamp to the
chassis.
Slide the cable clamp towards the front of the computer to free it from the
securing tabs on the computer chassis, then lift the cable clamp up and
away from the computer.
1
power supply
2
protruding lip of the chassis
3
screw
4
cable clamp
Gather the power supply cable bundles that stem from the power supply,
for easy removal.
Slide the power supply towards the front of the computer, to free it from
the securing tabs on the computer chassis.
Slide the power supply towards the expansion cards, to clear the
protruding lip of the chassis.
Lift the power supply up and out of the computer.
Installing the Power Supply
Slide the power supply into place, ensuring that the tabs on the rear wall of
the computer chassis latch into place.
Replace the four screws that secure the power supply to the back of the
computer chassis.
Reroute the DC power cables as you found them.
Insert the tab along the bottom of the cable clamp into the corresponding
slot on the chassis, then slide the cable clamp towards the rear of the
computer chassis until it snaps into place.
Replace the screw that secures the cable clamp to the chassis.
