Back to Contents Page

Replacing Memory Module(s)

Dell™ XPS™ 625 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

1. Follow the procedures in Before You Begin.
   
   
2. Remove the computer cover (see Replacing the Computer Cover).
   
   
3. Locate the memory modules on the system board (see System Board Components).
   
   
4. Press out the securing clip at each end of the memory module connector.
   
   

1

securing clip

2

memory module connector

5. Grasp the memory module and pull it upwards.
   
   

If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the connector.

CAUTION: Do not install ECC memory modules.

6. To install memory module(s), align the notch on the bottom of the module with the tab in the connector.
   
   

1	cutouts (2)	2	memory module
3	notch	4	tab

CAUTION: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the module.

7. Insert the module into the connector until the module snaps into position.
   
   

If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.

8. Replace the computer cover (see Replacing the Computer Cover).
   
   
9. Connect your computer and devices to electrical outlets, and then turn them on.
   
   

If the message appears stating that memory size has changed, press <F1> to continue.

10. Log on to your computer.
    
    
11. Right-click the My Computer icon on your Microsoft^® Windows^® desktop and click Properties.
    
    
12. Click the General tab.
    
    
13. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
    
    

Back to Contents Page