CAUTION: Before
you begin any of the procedures in this section, follow the safety
instructions in the System Information Guide.
NOTICE: Before
disconnecting a device from the computer or removing a component from the
system board, verify that the standby power light on the system board has
turned off. To locate this light, see "System
Board Components."
Disconnect the fan power cable from its
connector on the system board. To locate this connector, see "System
Board Components."
Press the release tabs outward from the
card fan guide, and lift the fan up and out of the guide.
NOTICE: Ensure that
the fan is properly installed on the guide. When the fan is properly
installed, the fan manufacturer label faces the expansion-card guide, and
the fan power cable extends toward the system board.
Insert the bottom of the fan into the clips on the card fan guide. Then press
the top of the fan toward the card fan guide until the tabs on the card fan
guide grasp the fan. See "Removing the Card Fan and
Guide."
If you need to remove the card fan guide, pull up on the card-fan
guide-release button and slide the guide up and out of the computer. To replace
the card fan guide, insert the card-fan guide anchor tabs into the slots on the
computer and slide the guide into position.
