Manuals

Manuals
Memory : Dell Vostro 1510 Service Manual

Back to Contents Page

Memory

Dell™ Vostro™ 1510 Service Manual

  Removing a Memory Module

  Replacing a Memory Module


Your computer has two user-accessible SODIMM sockets, both accessed from the bottom of the computer.

You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup and Quick Reference Guide for information on the memory supported by your computer. Install only memory modules that are intended for your computer.

NOTE: Memory modules purchased from Dell are covered under your computer warranty.

Removing a Memory Module

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
  1. Follow the procedures in Before Working on Your Computer.

  2. Turn the computer upside down.

  3. Remove the two screws that secure the memory cover, then remove the cover and set it aside. (See Removing a Memory Module for an illustration of the memory cover.)

1

memory cover

2

screws (2)

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
  1. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up.

  2. Remove the memory module from the connector.

1

securing clips (2)

2

memory module


Replacing a Memory Module

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

This procedure assumes that you have completed the removal procedure Removing a Memory Module.

  1. Align the notch in the module edge connector with the tab in the connector slot.

  2. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure.

1

tab

2

notch

NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.
  1. Replace the memory cover and tighten the screws.

  2. Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.

  3. Turn on the computer.

As the computer boots, it detects the additional memory and automatically updates the system configuration information.

To confirm the amount of memory installed in the computer:

  • In the Microsoft® Windows® XP operating system, right-click the My Computer icon on your desktop, and click Properties® General.

  • In Microsoft Windows Vista®, click Start ® Help and Support® Dell System Information.


Back to Contents Page

 

© 2008 Dell | About Dell | Terms of Sale | Unresolved Issues | Privacy | Contact | Site Map | Feedback

Top
sn EB15