Back to Contents Page

Hard Drive

Dell™ Vostro™ 1510
Service Manual

  Removing the Hard Drive

  Replacing the Hard Drive

NOTE: Dell does not guarantee compatibility or provide support for hard drives obtained from sources other than Dell.

Removing the Hard Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

CAUTION: Do not touch the metal housing of the hard drive if you remove the hard drive from the computer while the drive is hot.

NOTICE: To prevent data loss, turn off your computer before removing the hard drive. Do not remove the hard drive while the computer is on or in Sleep state.

NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.

1. Follow the procedures in Before Working on Your Computer, ensuring that you remove the battery.
   
   
2. Close the display and turn the computer upside down.
   
   
3. Remove the two M2.5 x 8-mm screws that secure the hard-drive compartment cover.
   
   
4. Remove the cover and set it aside.
   
   

NOTICE: When the hard drive is not in the computer, store the drive in protective antistatic packaging.

5. Remove the three screws securing the hard drive.
   
   
6. Pull the plastic tab to release the hard drive.
   
   
7. Lift the hard drive out of the computer.
   
   
8. Remove the two screws securing the hard drive to the hard drive bracket.
   
   
9. Slide the hard drive out of the bracket.
   
   

Replacing the Hard Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.

NOTICE: Use firm and even pressure to slide the hard drive into place. Excessive force may result in damage to the connector.

This procedure assumes that you have completed the removal procedure Removing the Hard Drive.

1. Slide the hard drive into the hard drive connector until the drive is fully seated in the bracket.
   
   
2. Replace the hard drive bracket into the system.
   
   
3. Replace the three screws securing the hard drive.
   
   
4. Replace the hard drive cover aligning the notches.
   
   
5. Replace the two M2.5 x 8-mm screws to secure the cover.
   
   
6. Install the operating system for your computer, as needed. For information on reinstalling the operating system, see the Setup and Quick Reference Guide for your computer on support.dell.com.
   
   
7. Install the drivers and utilities for your computer, as needed. For information on reinstalling drivers and utilities, see the Setup and Quick Reference Guide for your computer on support.dell.com.
   
   

Back to Contents Page