On the underside of the palm rest, remove the M2 x 3-mm screw from the
fingerprint reader cover, and lift the fingerprint reader cover out of the
palm rest.
Rotate the retaining bracket on the fingerprint reader connector on the
palm rest upward to release the fingerprint-reader cable connector.
Remove the fingerprint reader from the palm rest.
1
M2 x 3-mm screw
2
fingerprint reader cover
3
underside of palm rest
4
fingerprint reader
5
fingerprint reader connector with retaining bracket
6
fingerprint reader cable
Replacing the Fingerprint Reader
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: Ensure that the touch pad cable and the cable for the internal card with Bluetooth® wireless technology are properly routed before snapping the palm rest into place.
NOTE: This procedure assumes that you have completed the removal procedure first.
Position the fingerprint reader on the underside of the palm rest.
Connect the fingerprint reader cable connector to the fingerprint reader
connector and rotate the retaining bracket downward to secure the cable.
Replace the fingerprint reader cover and replace the M2x3-mm screw that
secures the cover to the palm rest.