Back to Contents Page

Before Working on Your Computer

Dell™ Vostro™ 1310 Service Manual

  Recommended Tools

  What You Need to Know for Your Safety

This document provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that:

• You have performed the steps in this section.
  
  
• You have read the safety information that shipped with your computer.
  
  
• When replacing a component, you have already removed the original, if installed.
  
  

NOTE: The color of your computer and certain components may appear differently than shown in this document.

Recommended Tools

The procedures in this document may require the following tools:

• Small flat-blade screwdriver
  
  
• Phillips screwdriver
  
  
• Small plastic scribe
  
  
• Flash BIOS update (see the Dell Support website at support.dell.com)
  
  

What You Need to Know for Your Safety

Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as a connector on the back of the computer.

NOTICE: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

NOTICE: When disconnecting a cable, pull on the cable's connector or on its strain-relief loop, not on the cable itself. For cable connectors with locking tabs, press inward on the locking tabs to release the connector. When connecting a cable, ensure that the connectors are correctly oriented and aligned to avoid damage to the connector and/or the connector's pins.

1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.
   
   
2. Shut down your computer.
   
   
   • In Microsoft® Windows® XP, click Start® Shutdown® Shutdown.
     
     
   • In Microsoft Windows Vista®, click Start , click the arrow icon, and then click Shut Down to turn off your computer.
     
     

NOTE: Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the operating system, press and hold the power button for 4 seconds.

3. Disconnect your computer and all attached devices from their electrical outlets.
   
   

NOTICE: To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the network wall jack.

4. Disconnect any telephone or network cables from the computer.
   
   
5. Remove any installed cards from the ExpressCard slot and the 8-in-1 memory card reader.
   
   

NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you service the computer.

NOTE: To avoid damage to the computer, use only the battery designed for this particular Dell™ computer. Do not use batteries designed for other Dell computers.

6. Turn the computer over.
   
   
7. Slide the battery lock to the open position.
   
   
8. Slide the battery latch release to the open position. (You may need to hold the latch release in the open position while removing the battery.)
   
   
9. Slide the battery out of the battery bay.
   
   

10. Turn the computer top-side up, open the display, and press the power button to ground the system board.
    
    

Back to Contents Page