WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the computer.
Remove the USB connector cable from the routing guide.
Disconnect the USB connector cable from the system board connector.
Lift the connector and cable out of the computer base.
1
USB cable connector
2
screw
3
USB connector cable routing
Replacing the USB Connector Cable
Place the USB connector cable in the computer base.
Replace the screw that secures the USB connector.
Route the USB connector cable through the routing guide.
Connect the USB connector cable to the system board connector.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.
