This section provides specific information about the jumpers on the system board. It also provides some basic information on jumpers and switches and describes the connectors and sockets on the various boards in the system.
Jumpers provide a convenient and reversible way of reconfiguring the circuitry on a printed circuit board. When reconfiguring the system, you may need to change jumper settings on the system board. You may also need to change jumper settings on expansion cards or drives.
Jumpers are small blocks on a circuit board with two or more pins emerging from them. Plastic plugs containing a wire fit down over the pins. The wire connects the pins and creates a circuit. To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated. Figure 5-1 shows an example of a jumper.
Figure 5-1. Example Jumper
CAUTION: Make sure the system is turned off before you change a jumper setting. Otherwise, damage to the system or unpredictable results may occur.
A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is no plug at all. When the plug is pushed down over two pins, the jumper is referred to as jumpered. The jumper setting is often shown in text as two numbers, such as 1-2. The number 1 is printed on the circuit board so that you can identify each pin number based on the location of pin 1.
Figure 5-2 shows the location and default settings of the jumper blocks on the system board. See Table 5-1 for the designations, default settings, and functions of the system's jumpers.
The password feature is enabled. The password feature is disabled.
NVRAM_CLR
(default)
The configuration settings are retained at system boot. The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point where the system will not boot, install the jumper plug and boot the system. Remove the jumper before restoring the configuration information.)
All prices exclude taxes and environmental advanced disposal surcharges where applicable. Prices subject to error, change and/or substitution at Dell's discretion at any time without notice. Dell cannot be responsible for errors in typography or photography. Unless otherwise specifically advertised, promotional offers are not combinable with any other offer or volume based or other discounts to which you may be entitled. Advertised configurations and limited time offers only available to customers in Canada. All purchases subject to Dell's Customer Agreement or Dell's standard terms of sale, Dell's limited warranty terms and the applicable Dell or third party service agreement. Copies available on request or at www.dell.ca. Remember to back-up your data. Dell is not responsible for lost or corrupt data or software. Limit one (1) offer per eligible system. Dell reserves the right to limit quantities to five (5) systems per customer.
unjumpered 
