|
Microprocessor
|
Microprocessor type |
Intel® Pentium® 4 and Celeron® microprocessors. Design provides for future processor upgrades. Supported processor upgrades are available from Dell. |
Level 1 (L1) cache |
8 KB |
Level 2 (L2) cache |
128-KB or 512-KB (depending on your computer configuration) pipelined-burst, eight-way set associative, write-back SRAM |
|
Memory
|
Architecture |
333- and 400-MHz DDR SDRAM |
Dual in-line memory module (DIMM) sockets |
two (non-ECC only) |
DIMM capacities |
128, 256, 512 MB, and 1 GB |
Minimum RAM |
128 MB |
Maximum RAM |
2 GB |
BIOS address |
F0000h |
|
Computer Information
|
Computer chip set |
Intel 865G |
Data bus width |
64 bits |
Address bus width |
32 bits |
Interrupts |
23 |
Computer BIOS |
4-Mb flash chip |
System bus speed |
800-, 533-, or 400-MHz quad-data rate; 200-, 133-, or 100-MHz clock (matches external bus speed) |
Network interface controller |
Gigabit integrated network interface with ASF 1.0 support as defined by DMTF Capable of 10/100/1000 communication |
|
Audio
|
Audio type |
AC97, Sound Blaster emulation; optional internal speaker |
Audio controller |
Integrated AC97 Codec |
Stereo conversion |
16-bit analog-to-digital; 20-bit digital-to-analog |
Interfaces: |
Internal |
PCI bus/AC97 |
External |
stereo line-in minijack and line-out minijack on the rear I/O panel; headphone and microphone connectors on the front panel |
|
Video
|
865G embedded graphics |
|
Expansion Bus
|
Bus type |
USB 2.0 |
Memory module connector size |
DDR — 184 pins |
|
Drives
|
Externally accessible bay |
one bay for Dell C-module portable devices |
Internally accessible bay |
one bay for a parallel ATA100 2.5-inch hard drive |
|
Ports
|
Externally accessible: |
Serial (data terminal equipment [DTE]) |
one 9-pin connector; 16550-compatible on the back I/O panel |
Parallel |
one 25-hole connector (bidirectional) on the back I/O panel |
Video |
DVI-I connector on the back I/O panel |
Integrated network adapter |
RJ45 connector on the back I/O panel; 10/100/1000 |
PS/2-style keyboard |
6-pin mini-DIN on the back I/O panel |
PS/2-compatible mouse |
6-pin mini-DIN on the back I/O panel |
USB |
four USB 2.0-compliant connectors on the back I/O panel; two on the front panel |
Internally accessible: |
Primary IDE hard drive |
44-pin connector |
Fans |
two 4-pin connectors |
|
Key Combinations
|
<Ctrl><Alt><Del> |
restarts (reboots) the computer |
<Ctrl><Alt><\> |
toggles microprocessor speeds on 101-key keyboard (in MS-DOS® real mode only) |
<Ctrl><Alt><#> |
toggles microprocessor speeds on 102-key keyboard (in MS-DOS real mode only) |
<F2> or <Ctrl><Alt><Enter> |
starts embedded system setup (during start-up only) |
<F3> |
automatically starts the computer from the network environment specified by the remote boot environment (PXE) rather than from one of the devices in the system setup Boot Sequence option (during start-up only) |
<F12> or <Ctrl><Alt><F8> |
displays a boot device menu that allows the user to enter a device for a single boot (during start-up only) as well as options to run hard-drive and system diagnostics |
<Ctrl><Alt><F10> |
launches the utility partition (if installed) during computer start-up |
|
Controls and Lights
|
Power control |
push button |
Power lights |
green light on power button—blinking green in sleep state; solid green for power-on state amber light—blinking amber indicates a problem with an installed device; solid amber indicates an internal power problem (see "Power Problems") |
Hard-drive access light |
green light |
Link integrity light (on integrated network adapter) |
green light for 10-Mb operation; orange light for 100-Mb operation; yellow light for a 1000-Mb (1-Gb) operation |
Activity light (on integrated network adapter) |
yellow blinking light |
Diagnostic lights |
four yellow and/or green lights on back panel |
Standby power light |
12V_PWR on the system board |
|
Power
|
External DC power adapter: |
Wattage |
150 W |
Heat dissipation |
455 BTU/hr (average) |
Voltage |
90 to 135 V at 60 Hz; 180 to 265 V at 50 Hz |
Backup battery |
3-V CR2032 lithium coin cell |
|
Physical
|
Vertical orientation width, depth, and height (without stand or cable cover) |
3.4 inches (8.5 cm), 9.7 inches (24.2 cm), 9.9 inches (24.7 cm) |
Vertical orientation width, depth, and height (with stand) |
3.4 inches (8.5 cm), 9.7 inches (24.2 cm), 10.9 inches (27.2 cm) |
Vertical orientation width, depth, and height (with stand and cable cover) |
3.4 inches (8.5 cm), 12.1 inches (30.2 cm), 10.9 inches (27.2 cm) |
Horizontal orientation width, depth, and height (without stand or cable cover) |
9.9 inches (24.7 cm), 9.7 inches (24.2 cm), 3.4 inches (8.5 cm) |
Weight (without stand or cable cover) |
7.2 lbs (3.3 kg) |
Weight (with stand and cable cover) |
8 lbs (3.6 kg) |
|
Environmental
|
Temperature: |
Operating |
10° to 30°C (50° to 86°F) |
Storage |
–40° to 65°C (–40° to 149°F) |
Relative humidity |
20% to 80% (noncondensing) |
Maximum vibration: |
Operating |
desktop or vertical hanging orientation: 0.25 gravities (G) at 3 to 200 Hz at 0.5 octave/min;
horizontal orientation: 0.25 G at 20 to 200 Hz at 0.5 octave/min |
Storage |
0.5 G at 3 to 200 Hz at 1 octave/min |
Maximum shock: |
Operating |
bottom half-sine pulse with a change in velocity of 20 inches/sec (50.8 cm/sec) |
Storage |
27-G faired square wave with a velocity change of 200 inches/sec (508 cm/sec) |
Altitude: |
Operating |
–16 to 3048 m (–50 to 10,000 ft) |
Storage |
–16 to 10,600 m (–50 to 35,000 ft) |
