|
Adding and Removing Parts: Dell OptiPlex GX60 Systems
User's Guide
Back to Contents Page
Adding and Removing Parts
Dell™ OptiPlex™ GX60 Systems
User's Guide
 |
CAUTION: Before
you begin any of the procedures in this section, follow the safety
instructions. |
|
CAUTION: To
guard against electrical shock, always unplug your computer from the
electrical outlet before opening the cover. |
- Perform an orderly computer shutdown using
the operating system menu.
 |
NOTICE: To
disconnect a network cable, first unplug the cable from your computer, and
then unplug it from the network wall jack. |
- Turn off any attached devices and
disconnect them from their electrical outlets.
- Disconnect the computer power cable from
the wall outlet, and then press the power button to ground the system board.
- Remove the
computer stand, if it is attached.
- If you have installed a padlock through
the padlock ring on the back panel, remove the padlock.
|
NOTICE: Ensure that
sufficient space exists to support the open coverat least 30 cm (1 ft)
of desktop space. |
- Locate the two release buttons
shown in the illustration, then press the two release buttons as you
lift the cover.
|
NOTICE: Open the cover slowly to ensure that you do not damage any cables.
|
- Raise the back of the cover, and pivot it toward the front of the computer.
1 | security cable slot |
2 | padlock ring |
3 | two release buttons (one on each side) |
Back to Contents Page
|
