Back to Contents Page

Cleaning Your Computer

Dell™ OptiPlex™ GX260 Systems User's Guide

  Computer, Keyboard, and Monitor

  Mouse

  Floppy Drive

  CDs and DVDs

CAUTION: Before you begin any of the procedures in this section, follow the steps in "CAUTION: Safety Instructions."

1. Perform an orderly computer shutdown using the operating system menu.
   
   

NOTICE: To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the network wall jack.

2. Turn off any attached devices and disconnect them from their electrical outlets.
   
   
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
   
   

Computer, Keyboard, and Monitor

• Use a vacuum cleaner with a brush attachment to remove dust from the slots and holes on your computer and between the keys on the keyboard.
  
  

NOTICE: Do not wipe the monitor screen with any soap or alcohol solution. Doing so may damage the antiglare coating.

• To clean your monitor screen, lightly dampen a soft, clean cloth with water. If possible, use a special screen-cleaning tissue or solution suitable for the monitor's antistatic coating.
  
  
• Wipe the keyboard, computer, and plastic part of the monitor with a soft cleaning cloth moistened with a solution of three parts water and one part liquid dishwashing detergent. Wipe off stubborn stains with a cloth lightly moistened with isopropyl alcohol.
  
  

Do not soak the cloth in the solution or allow the solution to drip inside your computer or keyboard.

Mouse

If your screen cursor skips or moves abnormally, clean the mouse. To clean a non-optical mouse:

1. Turn the retainer ring on the underside of your mouse counterclockwise, and then remove the ball.
   
   
2. Wipe the ball with a clean, lint-free cloth.
   
   
3. Blow carefully into the ball cage to dislodge dust and lint.
   
   
4. If a buildup of dirt exists on the rollers inside the ball cage, clean the rollers with a cotton swab moistened lightly with isopropyl alcohol.
   
   
5. Recenter the rollers in their channels if they are misaligned. Ensure that fluff from the swab is not left on the rollers.
   
   
6. Replace the ball and retainer ring. Turn the retainer ring clockwise until it clicks into place.
   
   

Floppy Drive

NOTICE: Do not attempt to clean drive heads with a swab. You might accidentally misalign the heads, which prevents the drive from operating.

Clean your floppy drive using a commercially available cleaning kit. These kits contain pretreated floppy disks to remove contaminants that accumulate during normal operation.

CDs and DVDs

1. Hold the disc by its outer edge. It is okay to touch the inside edge of the center hole.
   
   

NOTICE: To prevent damaging the surface, do not wipe in a circular motion around the disc.

2. With a soft, lint-free cloth, gently wipe the bottom of the disc (the unlabeled side) in a straight line from the center to the outer edge of the disc.
   
   

For stubborn dirt, try using water or a diluted solution of water and mild soap. You can also purchase commercial products that clean discs and provide some protection from dust, fingerprints, and scratches. Cleaning products for CDs are safe to use on DVDs.

Back to Contents Page