Back to Contents Page

Stand

Dell™ OptiPlex™ GX240 Systems User's Guide

  Removing the Computer Stand

  Attaching the Computer Stand

Removing the Computer Stand

1. Turn the computer over so that the stand is at the top.
   
   
2. Loosen the thumb screw and lift the stand away (see the following figures).
   
   
3. Place the computer in a horizontal position.
   
   

Small Form-Factor Computer

Small Desktop Computer

Attaching the Computer Stand

1. Place the computer on its right side so that the drive bays are at the bottom.
   
   
2. Fit the stand onto what was the left side of the computer.
   
   
   1. Position the stand as shown in the figure by aligning the large round hole in the stand with the securing button on the side of the cover and aligning the captive screw in the stand with the screw hole in the cover.
      
      
   2. When the stand is in place, tighten the thumbscrew.
      
      
3. Rotate the computer so that the stand is at the bottom and the drives are at the top.
   
   

Back to Contents Page