Back to Contents Page

Chassis Intrusion Switch

Dell™ OptiPlex™ 745 User's Guide

  Removing the Chassis Intrusion Switch

  Replacing the Chassis Intrusion Switch

  Resetting the Chassis Intrusion Detector

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTE: The chassis intrusion switch is optional on mini tower, desktop and small form-factor computers; it may not be present on your system.

Removing the Chassis Intrusion Switch

1. Follow the procedures in Before You Begin.
   
   
2. Disconnect the chassis intrusion switch cable from the system board.
   
   

Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in place inside the chassis.

3. Slide the chassis intrusion switch out of its slot, and remove the switch and its attached cable from the computer.
   
   

Mini Tower Computer

Desktop Computer

Small Form Factor Computer

Ultra Small Form Factor Computer

Replacing the Chassis Intrusion Switch

1. Gently slide the chassis intrusion switch into its slot and reconnect the cable to the system board.
   
   
2. Replace the computer cover (see Replacing the Computer Cover).
   
   
3. If you are using a computer stand, attach it to the computer.
   
   

Resetting the Chassis Intrusion Detector

1. Turn on (or restart) your computer.
   
   
2. When the blue DELL™ logo appears, press <F2> immediately.
   
   

If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows® desktop. Then shut down your computer and try again.

3. Select the Chassis Intrusion option and then press the left- or right-arrow key to select Reset. Change the setting to On, On-Silent, or Disabled.
   
   

NOTE: The default setting is On-Silent.

4. Press <Alt><b> to restart the computer and implement your changes.
   
   

Back to Contents Page