Removing the Right-Speaker and Fingerprint
Reader Cover
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.
CAUTION: Hard drives are fragile. Handle them carefully.
NOTE: If you don't have a fingerprint reader, ignore steps to remove or install the reader.
Loosen the two captive screws (indicated by an S stenciled on the base
plate).
1
captive screws (2)
Turn the computer top-side up.
Remove the fingerprint reader cable (if you have a fingerprint reader).
Remove the speaker/fingerprint reader cover.
Replacing the Right-Speaker and Fingerprint
Reader Cover
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.
CAUTION: If you are installing a new fingerprint reader/speaker cover assembly, remove the backing paper from the bottom of the cable.
If you have a fingerprint reader, connect the fingerprint reader cable. Press
along the cable to seal the cable into the palm rest.
Snap the speaker/fingerprint reader cover into place
Turn the computer upside down, and tighten the two M2.5 x 5-mm
captive screws.