Back to Contents Page

Microprocessor Module

Dell™ Latitude™ D810 Service Manual

  Removing the Microprocessor Module

  Installing the Microprocessor Module

Removing the Microprocessor Module

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE: To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

1. Follow the instructions in "Preparing to Work Inside the Computer."
   
   
2. Remove the hard drive.
   
   
3. Remove the center control cover.
   
   
4. Remove the display assembly.
   
   
5. Remove the keyboard.
   
   
6. Remove the palm rest.
   
   

NOTICE: To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the thermal-cooling assembly. The oils in your skin reduce the heat transfer capability of the thermal pads.

7. Remove the thermal-cooling assembly.
   
   
8. Loosen the ZIF socket holding the microprocessor. To loosen the ZIF socket, use a small, flat- blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
   
   

NOTICE: When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.

1	ZIF-socket cam screw
2	pin-1 corner

9. Lift out the microprocessor module.
   
   

Installing the Microprocessor Module

NOTICE: Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module properly in the ZIF socket does not require force.

NOTICE: A microprocessor module that is not properly seated can result in an intermittent connection or permanent damage to the microprocessor and ZIF socket.

1. Align the pin-1 corner of the microprocessor module with the pin-1 corner of the ZIF socket, and insert the microprocessor module.
   
   

NOTE: The pin-1 corner of the microprocessor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.

NOTICE: You must position the microprocessor module correctly in the ZIF socket to avoid permanent damage to the module and the socket.

When the microprocessor module is correctly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the others, the module is not seated correctly.

2. Tighten the ZIF socket by turning the cam screw clockwise to secure the microprocessor module to the system board.
   
   
3. Perform the steps in "Removing the Microprocessor Module" in reverse order, beginning with step 7.
   
   
4. Update the BIOS using a flash BIOS update program CD. For instructions on how to flash the BIOS, see "Flashing the BIOS."
   
   

Back to Contents Page