Back to Contents Page

Display Assembly

Dell™ Latitude™ D800 Service Manual

  Display Assembly

  Display Bezel

  Display Panel


Display Assembly

CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest.
  1. Follow the instructions in "Preparing to Work Inside the Computer."

  2. Turn the computer over and remove the two M2.5 x 12-mm screws labeled "D" on the bottom of the computer.

  1. Turn over the computer and open the display.

  2. Remove the central control cover.

  3. Disconnect the display cable using the pull-tab, and release the cable from the four cable-routing clips.

NOTE: When you replace the display assembly, ensure that you route the display cable under the EMI clip and cable-routing clips.
  1. Lift the display out of the computer.

1

display

2

display cable connector

3

computer base

4

pull-tab

5

connector

1

M2.5 shoulder screws (2)

4911U

4

M2 x 6-mm screws (6)

4911U

2

Screw covers (2)

4W401

5

display bezel

8T884

3

display bumpers (6)

6W052

6

M2 x 3-mm screws (9)

 

Display Bezel

CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
  1. Follow the instructions in "Preparing to Work Inside the Computer."

  2. Remove the central control cover.

  3. Remove the display assembly.

  4. Use a plastic scribe to pry the eight display bumpers out of the screw holes located on the front of the bezel.

  5. Remove the eight M2.5 x 6-mm screws located on the front of the bezel.

NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
  1. Starting at the bottom of the display panel (by the DELL™ logo), use your fingers to separate the bezel from the top cover by lifting the inside edge of the bezel away from the top cover.

Display Panel

CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
  1. Follow the instructions in "Preparing to Work Inside the Computer."

  2. Remove the central control cover.

  3. Remove the display assembly.

  4. Remove the display bezel.

  5. Remove the nine M2 x 3-mm screws from the display panel.

  6. Lift the display panel, and rotate the display panel out of the top cover.

  7. Remove the yellow tape from the top display connector.

  8. Press in the tabs on both sides of the top display-cable connector, and pull the display cable connector away from the top flex-cable connector.

1

top flex-cable connector

2

top display-cable connector

3

tabs

  1. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.

1

top flex-cable connector

2

top display-cable connector

3

pull-tab on bottom flex-cable connector

  1. Remove the yellow tape from above the bottom flex-cable connector.

Back to Contents Page