CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.
Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the
cable from the system board.
Disconnect the antenna cable(s).
Carefully remove the antenna cable and the display cables from their routing guides.
Close the display.
Turn the computer upside-down with the back of the computer facing you.
From the bottom of the computer, remove the two M2.5 x 8-mm screws labeled "D."
From the back of the computer, remove the two M2.5 x 8-mm screws.
Turn the computer right-side up and open the display.
1
antenna cables
2
display cable
Lift the display assembly out of the computer base.
Removing the Display Bezel
CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.
Use a plastic scribe to pry the six circular screw covers/bumpers out of the screw holes on the front of
the bezel.
Remove the six M2.5 x 5-mm screws from the front of the bezel.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
Starting from the inside edges of bezel, use your fingers to pry the bezel upward and outward from the
display panel.
1
screw covers/display bumpers (6)
2
M2.5 x 5-mm screws (6)
3
display bezel
4
top cover
Removing the Display Panel
CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.
Remove the four M2 x 3-mm screws from each side of the display panel.
Lift the display panel out of the top cover.
1
display panel
2
top cover
3
M2 x 3-mm screws (4)
4
notches for cable routing
Installing the Display Panel
Replace the eight M2 x 3-mm screws that secure the display panel to the top cover.
Route the display-feed flex cable and antenna cables so that they rest in the notch located in the
bottom edge of the top cover.
Replace the display bezel.
Removing the Display Hinges
CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.
