Turn the computer over and remove the three M2.5 x 12-mm screws
labeled "circle P."
1
M2.5 x 12-mm screws (3)
2
M2 x 3-mm screws (2)
3
hard-drive bay door
Remove the two M2 x 3-mm screws that are located in the hard-drive
bay door labeled "circle P."
Turn the computer over, and remove the three M2 x 3-mm screws that
secure the palm rest to the bottom case:
Remove the two M2 x 3-mm screws that are located on the back
edge of the bottom case, underneath the display assembly.
Remove the M2 x 3-mm screw located near the right side of the
bottom case, next to the microprocessor thermal cooling assembly
and opposite the S-video TV-out connector.
Pull up on the pull-tab that is attached to the palm-rest flex cable
connector to remove it from the interface connector on the system
board.
1
M2 x 3-mm screws (3)
2
palm rest
3
palm-rest flex cable
4
bottom case
5
interface connector for palm-rest flex cable
6
back center of the palm rest
NOTICE: Carefully separate the palm rest from the bottom case to avoid
damage to the palm rest.
Starting at the back center of the palm rest, use your fingers to
separate the palm rest from the bottom case by lifting the inside of the
palm rest while pushing in on the outside.