Battery Latch Assembly: Dell Inspiron 9300 Service Manual
Back to Contents Page
Dell™ Inspiron™ 9300 Service Manual
Removing the Battery Latch Assembly
Replacing the Battery Latch Assembly
CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide .
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
Follow the instructions in "Before Working Inside Your Computer ."
Remove the hinge cover .
Remove the keyboard .
Remove the display assembly .
Remove the palm rest .
Remove the system board .
Remove the hard drive bay by removing the four M2 x 3-mm screws, and lifting out the bay.
1
hard drive bay
2
M2 x 3-mm screws (4)
Remove the screw in the battery latch assembly.
When you remove the screw, the battery latch release on the bottom of the computer will also be removed.
1
screw
2
battery latch assembly
Remove the spring from the hook on the computer base by lifting it up and away with a
screwdriver or a plastic scribe.
Remove the plastic battery-latch assembly by twisting the assembly slightly and lifting it out
of the channel and away from the computer base.
Insert the latch assembly into the channel on the computer base, and press it into place.
Using a small screwdriver, hook the spring over the hook on the computer base.
Place the battery latch release under the computer base, line it up with the hole in the base,
and then replace the screw in the assembly.
Ensure that the newly installed latch moves smoothly and freely when pushed and released.
Replace the hard drive bay and reinsert the four M2 x 3-mm screws.
Replace the system board .
Replace the other components removed in "Removing the Battery Latch Assembly " in reverse
order.
Back to Contents Page
