Back to Contents Page

USB Port Board

Dell™ Inspiron™ 9300 Service Manual

  Removing the USB Port Board

  Replacing the USB Port Board

Removing the USB Port Board

CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

1. Follow the instructions in "Before Working Inside Your Computer."
   
   
2. Remove the hinge cover.
   
   
3. Remove the keyboard.
   
   
4. Remove the display assembly.
   
   
5. Remove the palm rest.
   
   
6. Disconnect the USB-port-board cable connector from the system board.
   
   
7. Remove the M2.5 x 5-mm screw, and lift the board up and out of the computer.
   
   

1	USB port board
2	M2.5 x 5-mm screw
3	notch
4	USB-port-board cable
5	system board connector
6	tab
7	pin

Replacing the USB Port Board

1. Insert the notch on the USB port board under the small tab on the computer base and the other side of the board over the pin.
   
   
2. Replace the M2.5 x 5-mm screw.
   
   
3. Reconnect the cable to the system board.
   
   
4. Perform the steps in "Removing the USB Port Board" in reverse order.
   
   
5. Replace the palm rest.
   
   
6. Replace the display assembly.
   
   
7. Replace the keyboard.
   
   
8. Replace the hinge cover.
   
   

Back to Contents Page