CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
Turn the computer over and loosen the two captive screws from the Mini PCI card cover.
NOTE: If a Mini PCI card is installed, you will need to remove the antenna cables from the card. If one is not installed, remove the antenna cables from their secured location.
Disconnect the antenna cables from the Mini PCI card.
If a wireless Mini PCI card is installed, connect the antenna cables from the card. If one is not
installed, connect the antenna cables to their secured location.
Replace the cover.
Display Bezel
1
display bezel
5
M2.5 x 3-mm screws (8)
2
M2.5 x 5-mm screws (6)
6
screw cover (2)
3
rubber display bumpers (6)
4
display panel
Removing the Display Bezel
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
Remove the two screw covers and the two shoulder screws.
Remove the six M2.5 x 5-mm screws around the display.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
Use your fingers to separate the bezel from the top cover by pulling the right bottom corner of
the bezel toward the bottom edge of the assembly to clear the tab on the bottom right corner.
(A) Then pull the bezel toward the toward the right edge of the assembly to clear the tab on
the lower right side. (B)
1
tabs
Repeat step 6 for the left corner of the bezel. Then use your fingers to release the snaps
around the rest of the bezel and lift it away from the cover.
Replacing the Display Bezel
Starting at any corner, use your fingers to gently snap the bezel in place securing the display
panel.
Replace the six M2.5 x 5-mm screws on the front of the bezel.
Replace the two shoulder screws and two screw covers.
Replace the six display bumpers around the display assembly.
Display Panel
Removing the Display Panel
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
