Back to Contents Page

Internal Card with Bluetooth® Wireless Technology

Dell™ Inspiron™ 9200

  Removing the Internal Card

  Replacing the Internal Card

Removing the Internal Card

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

NOTE: If you ordered a Bluetooth card with your computer, the card is already installed.

1. Follow the instructions in "Before Working Inside Your Computer."
   
   
2. Remove the battery.
   
   
3. Remove the M2.5 x 8-mm screw and remove the card cover from the computer.
   
   
4. Pull the card out of the compartment so that you can disconnect the card from its cable and remove it from the computer.
   
   

1	Bluetooth card door
2	Bluetooth card
3	Bluetooth card connector

Replacing the Internal Card

1. To replace the card, connect the card to the cable and then carefully insert it into the compartment.
   
   
2. Replace the card cover and the screw.
   
   
3. Replace the battery.
   
   

Back to Contents Page