Back to Contents Page

Camera (Optional)

Dell™ Inspiron™ 910 Service Manual

  Removing the Camera

  Replacing the Camera

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

Removing the Camera

1. Follow the instructions in Before You Begin.
   
   
2. Remove the module cover (see Removing the Module Cover).
   
   
3. Remove the keyboard (see Removing the Keyboard).
   
   
4. Remove the palm rest (see Removing the Palm Rest).
   
   
5. Remove the display assembly (see Display Assembly).
   
   
6. Remove the display bezel (see Display Bezel).
   
   

1

camera

2

camera cable connector

7. Disconnect the camera cable from the connector.
   
   
8. Remove the camera board.
   
   

Replacing the Camera

1. Align the camera board over the slot holes and gently replace it.
   
   
2. Reconnect the camera cable to the connector.
   
   
3. Replace the display bezel (see Replacing the Display Bezel).
   
   
4. Replace the display assembly (see Replacing the Display Assembly).
   
   
5. Replace the palm rest (see Replacing the Palm Rest).
   
   
6. Replace the keyboard (see Replacing the Keyboard).
   
   
7. Replace the module cover (see Replacing the Module Cover).
   
   
8. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
   
   

Back to Contents Page