Back to Contents Page

Internal Card With Bluetooth® Wireless Technology

Dell Inspiron™ 6000 Service Manual

  Removing the Card

  Replacing the Card

Removing the Card

CAUTION: Before you perform the following procedures, see the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

NOTE: If you ordered an internal card with Bluetooth wireless technology with your computer, the card is already installed.

1. Follow the instructions in "Preparing to Work Inside the Computer."
   
   
2. Remove the battery.
   
   

NOTICE: The card door has a ribbon that is connected to the internal card with Bluetooth wireless technology attached. Be careful when removing the card door. Failure to do so could damage the ribbon cable and the Bluetooth card.

3. Use a plastic scribe to pry the card door open.
   
   

1	card door ribbon
2	internal card with Bluetooth wireless technology
3	card door

4. Disconnect the card from the card door ribbon.
   
   

1	card connector
2	internal card with Bluetooth wireless technology

Replacing the Card

1. To replace the card, connect the card to the cable and insert it into the compartment.
   
   
2. Replace the card door by inserting the small center tab into the notch at the base of the compartment, and snap the door into place.
   
   
3. Replace the battery.
   
   

Back to Contents Page