Back to Contents Page

Replacing the Computer Cover

Dell™ Dimension™ 9200C Service Manual

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

1. Ensure that all cables are connected and folded out of the way.
   
   

Gently pull the power cables toward you so that they do not get caught underneath the drives.

2. Ensure that no tools or extra parts are left inside the computer.
   
   
3. Install the cover:
   
   
   1. Align the bottom of the cover with the tabs located along the bottom of edge of the computer.
      
      
   2. Using the tabs as leverage, rotate the cover downward.
      
      

3. Press down on the right side of the cover until it closes.
   
   
4. Press down on the left side of the cover until it closes.
   
   
5. Ensure that both sides of the cover are locked before moving the computer to the upright position.
   
   

NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the computer.

4. Connect your computer and devices to electrical outlets, and then turn them on.
   
   

Back to Contents Page