Back to Contents Page

Attaching and Removing the Computer Stand

Dell™ Dimension™ 4700C Service Manual

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTE: Place your computer on a soft surface to prevent scratching the top cover.

To attach the stand:

1. Rotate the computer to an upside-down position.
   
   
2. Insert the screw into the bottom of the stand.
   
   
3. Align the two tabs and the screw on the stand with the tab holes and screw hole in the bottom of the computer.
   
   

4. Tighten the screw.
   
   
5. Place the computer in the upright position.
   
   

To remove the stand:

1. Turn the computer over so that the stand is at the top.
   
   
2. Loosen the screw and lift the stand away.
   
   
3. Place the computer in a horizontal position until you reattach the stand.
   
   

Back to Contents Page