Back to Contents Page

Replacing the Computer Cover

Dell™ Dimension™ 4590T Service Manual

1. Ensure that no tools or extra parts are left inside the computer.
   
   
2. Replace the cover:
   
   
   1. Lower and align the cover with the two lines on the metal computer frame.
      
      
   2. Slide the cover until you hear or feel it click into place.
      
      

1	alignment lines

NOTICE: To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.

3. Connect your computer to its power adapter and connect devices to electrical outlets, and turn them on.
   
   

After you replace the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer start-up:

ALERT! Cover was previously removed.

4. Reset the chassis intrusion detector by changing Chassis Intrusion to Enabled or Enabled-Silent.
   
   

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.

Back to Contents Page