Manuals

Control Panel Removal (Mini Tower): Dell Precision™ WorkStation 210 Systems

1. Disconnect the control panel cable from the PANEL connector on the system board.
2. Remove the card guide. Be sure to remove the control panel cable from the slot on the inner side of the card guide.
   Note the routing of the control panel cable as you remove it from the chassis. It is important to route the cable properly when you replace it to prevent it from being pinched or crimped.
3. Disconnect the speaker cable connector, the chassis intrusion switch cable connector, and the thermal sensor cable connector from the control panel.
4. Remove the mounting screw that secures the control panel to the chassis.
5. Remove the control panel cable.
   Open the drive cage door, pull the control panel cable through the opening in the front wall, and carefully remove the cable from the routing tab in the drive cage door.
6. Pull out on the control panel to detach it from the chassis.