Manuals

Optional Stand: Dell OptiPlex GX1 Small-Form-Factor System User's Guide

Back to Contents Page

Optional Stand: Dell™ OptiPlex™ GX1 Small-Form-Factor System User's Guide

To remove the optional stand, perform the following steps:

Turn the computer over so that the stand is at the top.

Loosen the captive screw and lift the stand away (see Figure 1).

Place the computer in a horizontal position.

Figure 1. Optional Stand

1	Stand
2	Computer
3	Captive screw hole
4	Captive screw

To attach the optional stand, perform the following steps.

NOTICE: Attach the optional stand to the computer only as described in this procedure. Operating the computer with the stand attached in any other position may damage the computer.

Turn the computer onto its right side.
Fit the stand onto what now is the top of the computer.

Position the stand as shown in Figure 1. Align the captive thumbscrew in the stand with the screw hole in the cover.

Tighten the thumbscrew.

Rotate the computer so that the stand is at the bottom.

Back to Contents Page