If the printer location needs to change or the printer and print media handling options need to be shipped to a new location, all print media handling options must be removed from the printer. For shipping, pack the printer and print media handling options securely to avoid damage.
Removing Optional Tray Modules
Removing the Optional Memory Card
Removing the Optional Multi Protocol Card
Removing the Optional Hard Drive
 |
NOTE: To lift the printer safely and replace the optional 500-sheet tray module or 1000-sheet tray module requires two people to stand in front (operator panel side) and behind the printer and to lift at the same time. Do not try to lift the printer from the sides. |
|
CAUTION: To lift the printer safely, remove the imaging drum and lift it with two people.
|
 |
NOTICE: Place the imaging drum on a clean flat surface. Also, cover the imaging drum with something like newspaper to keep it out of direct light. |
Some instructions may vary depending on the tray module configuration in your printer.
- Turn off the printer and unplug the printer power cable.
- Remove the paper tray cover from the back of the printer.
- Pull the printer's tray out until it stops. Hold the tray with both hands, lift the front slightly and remove it from the printer.
- Using a coin, remove the four screws inside the printer.
- Gently lift the printer off the tray module, and place it on a level surface.
- Insert the tray into the printer. Reattach the paper tray cover to the back of the printer.
- Make sure that the printer is turned off and unplug all cables including the power cord from the rear of the printer.
- Pull the paper tray cover so that the top edge tilts out, then lift the paper tray cover off its hinges.
- Remove the three screws on the controller card from the back side of the printer.
- Remove the controller card from the printer by the handles.
- Place the controller card on the table so that its edge hangs over the edge of the table and the controller card is horizontal. Push the clips on both sides of the slot outward. Remove the memory card from the slot.
- Insert the controller card into the printer.
- Tighten the three screws on the controller card from the back side of the printer.
- Reattach the paper tray cover to the back of the printer.
- Make sure that the printer is turned off and unplug all cables including the power cord from the rear of the printer.
- Pull the paper tray cover so that the top edge tilts out, then lift the paper tray cover off its hinges.
- Remove the three screws on the controller card from the back side of the printer.
- Remove the controller card from the printer by the handles.
- Replace the two screws from the back side of the controller card.
- Hold the multi protocol card and remove it from the controller card.
- Insert the controller card into the printer.
- Tighten the three screws on the controller card from the back side of the printer. The two screws on the upper side are different in shape from the one on the lower side. Be careful not to confuse them.
- Reattach the paper tray cover to the back of the printer.
- Make sure that the printer is turned off and unplug all cables including the power cord from the rear of the printer.
- Pull the paper tray cover so that the top edge tilts out, then lift the paper tray cover off its hinges.
- Remove the three screws on the controller card from the back side of the printer.
- Remove the controller card from the printer by the handles.
- Replace the two screws from the back side of the controller card.
- Hold the hard drive and remove it from the controller card.
- Insert the controller card into the printer.
- Tighten the three screws on the controller card from the back side of the printer. The two screws on the upper side are different in shape from the one on the lower side. Be careful not to confuse them.
- Reattach the paper tray cover to the back of the printer.
