Installing the Toner Cartridges and Imaging Drum

CAUTION: Before performing any of the following procedures, read and follow the safety instructions in your Owner's Manual.

Installing the Toner Cartridge

Remove the top cover.

Pull the toner seal for each toner cartridge straight up to remove it.

NOTE: Pull the toner seal straight up. Pulling the toner seal diagonally may tear the seal.

Replace the top cover by inserting its front side into the printer first.

Installing the Imaging Drum

CAUTION: Make sure nothing touches or scratches the surface of the light-sensitive drum surface (green-colored roller) or the transfer roller (black-colored roller). Scratches, dirt, or oil from your hands on the imaging drum or transfer roller may reduce the print quality.

Push the front latch up and fully open the front cover.

Push the button as shown in the following illustration and open the imaging drum cover.

Remove the protective cover from the imaging drum.

Holding the imaging drum by the handle with the flat part facing the back of the printer, align the plastic guides on both sides of the imaging drum with the slots in front of the arrows on the printer. Gently lower the imaging drum into the printer.

NOTICE: Lowering the cartridge into the printer without correctly aligning the rollers with the slots can damage the cartridge.

NOTICE: Do not allow the surface covered with a protective sheet to come into contact with anything.

Pull the protective cover on the imaging drum straight up to remove it.

NOTICE: Do not touch the transfer roller (black-colored roller). Make sure that nothing touches or scratches the roller surface. Scratches or oil from your hands on the roller deteriorates print quality.

Close the imaging drum cover.

Close the front cover.