Removing Options

If the printer location needs to change or the printer and print media handling options need to be shipped to a new location, all print media handling options must be removed from the printer. For shipping, pack the printer and print media handling options securely to avoid damage.

  Removing the Optional Duplex Module

  Removing Optional Tray Modules

  Removing the Optional Memory Card

  Removing the Optional Multi Protocol Card

Removing the Optional Duplex Module

1. Remove the connector cover supplied with the duplex module.
   
   

2. Disconnect the connector at the bottom left of the module. Then, attach the original connector cover into the connector.
   
   

3. Turn off the printer and unplug the printer power cable.
   
   
4. Remove the screws on the left and right at the bottom of the duplex module while firmly holding the optional duplex module in a closed state.
   
   

5. Grab the optional duplex module and pull down.
   
   

6. Remove the screws of the straps on the left and right of the module from the optional duplex module.
   
   

7. Remove the optional duplex module from the printer.
   
   

8. Gently push both sides of the bottom of the paper cover to install it.
   
   

9. Open the inner rear cover. Attach the cover, which you have kept since installing the duplex module, until it clicks, and then close the rear cover.
   
   

Removing Optional Tray Modules

CAUTION: To lift the printer safely and replace the optional 250-sheet tray module or 500-sheet tray module requires two people to stand in front (operator panel side) and behind the printer and to lift at the same time. Do not try to lift the printer from the sides.

CAUTION: Make sure your fingers are not under the printer when you set it down.

NOTE: You can use a maximum of two trays with your printer (the standard 250-sheet tray module and one additional 250-sheet tray module or 500-sheet tray module).

1. Turn off the printer and unplug the printer power cable.
   
   
2. Unlock the tray from the printer by removing the tray from the tray module and turning the locking mechanism, inside the printer, as shown in the graphic.
   
   

3. Remove the printer from the tray.
   
   

CAUTION: Lift the printer with two people, one facing the front of the printer (operator panel side) and the other facing the back. Never try to lift the printer while facing its right and left sides.

4. To unlock the trays, loosen the screws with a coin and remove them from the inside of the tray.
   
   

5. Remove the optional 250-sheet tray module or 500-sheet tray module.
   
   

6. Place the printer on top of the standard 250-sheet tray module.
   
   

7. Lock the standard 250-sheet tray module into place by removing the tray from the tray module and rotating the locking mechanism as shown in the graphic.
   
   

8. Replace all trays.
   
   

Removing the Optional Memory Card

1. Make sure that the printer is turned off.
   
   
2. Remove the control board cover on the left side of the printer by pulling the notch.
   
   

3. Push the knobs on both sides of the slot outward. Remove the memory card from the slot.
   
   

4. Reattach the control board cover to the printer.
   
   

For more information, see "Installing Cards".

Removing the Optional Multi Protocol Card

1. Make sure that the printer is turned off.
   
   
2. Remove the control board cover on the left side of the printer by pulling the notch.
   
   

3. Loosen the two screws from the back side of the printer.
   
   

4. Hold the bottom of the multi protocol card and remove it from the control board.
   
   

5. Reattach the control board cover to the printer.
   
   

For more information, see "Installing Cards".