Installing the Toner and Drum Cartridges

  Installing the Toner Cartridge

  Installing the Drum Cartridge

CAUTION: Before performing any of the following procedures, read and follow the safety instructions in your Owner's Manual.

Installing the Toner Cartridge

Install or replace the toner cartridge while the printer is on (if the power is not on, the cartridge carrier will not rotate).

1. After confirming the Insert Yellow Toner (Y)message, open the front door.
   
   

2. Hold the tape on the protective cover and pull it forward to remove the cover from each cartridge slot.
   
   

NOTE: You need to remove the protective cover only the first time that you install the toner.

NOTE: Dispose of the protective cover after you remove it.

NOTE: The protective cover is attached to each toner cartridge mount.

3. Make sure the color of the toner cartridge matches the slot on the toner cartridge carrier. The order is Y, M, C, K. Gently shake the cartridge to distribute the toner evenly.
   
   

4. Lift the tab up 90 degrees and pull the toner seal straight off, keeping it parallel with the toner cartridge.
   
   

5. To insert the toner cartridges, align the arrows on the cartridge with the corresponding arrows on the printer. Guide the cartridge in until it snaps into place and then push down the handhold to lock the cartridge in place.
   
   

6. Close the front door.
   
   

NOTE: Make sure the toner cartridge is installed correctly. Otherwise, the front door cannot close firmly.

7. The toner cartridge carrier rotates to the next empty slot. When the color of the newly inserted cartridge appears on the display, followed by the Insert message, insert the next toner cartridge.
   
   
8. Repeat steps 1 through 7 when inserting the remaining cartridges.
   
   

Installing the Drum Cartridge

1. When the Insert Drum or Insert Drum Cart message appears, open the front door, then lift and push back the top cover.
   
   

2. Remove the protective sheet from the drum cartridge.
   
   

3. To insert the drum cartridge, push up the lever on the right side of the printer. With the lever in the upright position, hold the drum cartridge by the handle, align the arrows on the drum cartridge with the corresponding arrows on the printer and guide the cartridge in until it snaps into place.
   
   

4. Pull down the lever on the right to lock the drum cartridge in place.
   
   

5. Close the top cover, then the front door.
   
   

NOTE: After installing the drum cartridge, the printer makes an adjustment for about one to two minutes. Do not turn off the printer during this time.