|
 | | |
Setup: Quantum Atlas 10K Hard Disk Drive User's Guide
Back
to Contents Page
Setup: Quantum Atlas� 10K Hard Disk Drive User's Guide
Dell Installed Drives
� Customer Kits
Dell Installed Drives
Dell performs the installation and setup on SCSI hard-disk
drives that are shipped as part of a system. The default SCSI ID for a
boot hard-disk drive installed in a Dell system is SCSI ID 0. After
installing the drive, Dell prepares the drive for operation with your operating
system. The drive is ready for use when you receive your system.
Drives Purchased Separately
as Customer Kits
Installation Guidelines
Consult the dell documentation for your
system to determine drive requirements, such as number, type, and physical
size of drives supported.
SCSI ID of the Drive
Default is SCSI ID 0.
Verify that there are no SCSI ID conflicts with
other SCSI devices.
SCSI Interface
The SCSI interface is 68-pin Wide LVD.
Termination
The Quantum Atlas IV drive cannot be configured
to provide bus termination. Therefore, be sure to properly terminate
the SCSI bus on which this drive is installed.
Installing the Drive
The mounting holes on the Quantum Atlas
IV hard-disk drive allow the drive to be mounted in any orientation.
For mounting, #6-32 UNC screws are recommended.
Preparing the Drive for Operation
The SCSI hard-disk drive is shipped from
the manufacturer low-level formatted in 512-byte sectors. Use the
programs provided with the SCSI host adapter card to prepare the drive
for operation.
Back to Contents Page
|
|
|
