|
Introduction: Toshiba SD-C2502 DVD-ROM User's Guide
Back to Contents Page
Introduction: Toshiba SD-C2502 DVD-ROM User's Guide
Manufacturer/Model •
Drive Speed •
BUS Interface •
Disc Formats •
General Features •
DVD Features •
CD-ROM Features •
DVD Configuration •
Front Panel
Toshiba SD-C2502
DVD-ROM: 8X
CD-ROM: 24X
ATAPI
- DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18)
- DVD-R (read)
- CD-DA
- CD+(E)G
- CD-MIDI
- CD-TEXT
- CD-ROM
- CD-ROM XA
- CD-I
- CD-I Bridge (Photo-CD, Video CD)
- Multi-session (Photo-CD, CD Extra, CD-RW, CD-R)
- CD-R (read)
- CD-RW (read)
Drawer Type Manual Load/Electrical Release
3-way Disc Eject (eject button, software, emergency eject hole)
100ms Average Access Time
Multi-Read Capability
Regionalization (RPC2 compliance)
Movie Playback at 1.6X - 2.4X
95ms Average Access Time
DAE (Digital Audio Extraction) Audio Capability
MPC3 Compatibility
This DVD-ROM drive should be used only in its current hardware and
software configuration.
Figure 1.SD-C2502 DVD-ROM Front Panel
| Eject Button |
The EJECT button is used to open the disc tray so you
can install or remove a disc. |
| Busy Indicator |
When you install a disc into the DVD-ROM drive, the
BUSY light flashes slowly as it attempts to locate the disc. One of the following will
occur:
- BUSY light goes out. The DVD-ROM drive is ready to read data from the
disc.
- BUSY light flashes slowly. The disc may be dirty.
- BUSY light remains ON. The DVD-ROM is accessing data.
- BUSY light remains ON indefinitely. The DVD-ROM is experiencing an
error
|
Emergency
Eject Hole |
The emergency eject hole is to be used only when the
DVD tray will not open when EJECT button is pressed. |
| DVD Tray |
Insert media disc in tray. |
Back to Contents Page
|
