Back to Contents
Page
Declaration of Conformity: Dell�
TrueMobile� 1100 Series 11Mbps Wireless LAN
Adapter
Declaration of Conformity
Statement • Canadian
Compliance Statement •
European Telecommunication
Standards Institute
Manufacturers Federal
Communication Commission Declaration of Conformity
Statement
Model: TM1100PC
FCC Certification number: LOZ 102038
(PC4800B Series); LOZ 102035 (LM4800B Series)
Manufacturer:
Aironet Wireless Communications, Inc.
3875 Embassy Parkway
Akron, OH 44333-8357
330-664-7900
This device complies with Part 15 rules.
Operation is sub-ject to the following two conditions:
1) This device may not cause harmful
interference, and 2) this device must accept any interference
received, including interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits of a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide rea-sonable
protection against harmful interference when the equipment is
operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful
interference. However, there is no guarantee that interference will
not occur. If this equipment does cause interference to radio or
television reception, which can be determined by turning the
equip-ment off and on, the user is encouraged to correct the
inter-ference by one of the following measures:
- Reorient or relocate the receiving
antenna.
- Increase separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit differ-ent from which the receiver is
connected.
- Consult the dealer or an experienced
radio/TV techni-cian.
|
|
|
|
User Warning: The Part 15 radio device
operates on a non-interference basis with other devices
operating at this frequency.
|
|
|
Department of Communications —
Canada
Canadian Compliance Statement
This Class B Digital apparatus meets all the
requirements of the Canadian Interference - Causing Equipment
Regulations.
Cet appareil numerique de la classe B respecte
les exi-gences du Reglement sur le material broilleur du
Canada.
This device complies with RSS-210 of Industry
of Canada. Operation is subject to the following two conditions: 1)
this device may not cause harmful interference, and 2) this device
must accept any interference received, including interference that
may cause undesired operation.
The device is certified to the requirements of
RSS-139-1 for 2.4 GHz spread spectrum devices. The use of this device
in a system operating either partially or completely outdoors may
require the user to obtain a license for the system according to the
Canadian regulations. For further informa-tion, contact your local
Industry Canada office.
European
Telecommunication Standards Institute
Statement of Compliance
Information to User
This equipment has been tested and found to
comply with the European Telecommunications Standard ETS 300.328.
This standard covers Wideband Data Transmission Sys-tems referred in
CEPT recommendation T/R 10.01.
This type accepted equipment is designed to
provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio fre-quency energy, and if not
installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Back to Contents
Page
