If
your Cable TV signal is a single, round cable (75 ohm), then you're
ready to connect to the TV.
Connect the TV cable to the ANTENNA/CABLE plug on the TV.
If
you have a cable converter box, connect the cable TV signal to the IN
(put) plug on the converter, connect the OUT(put) plug from the converter
to the 75 (ohm) plug on
the TV.
Verify that the On Screen Display (OSD) is set to Cable.
Note: The connecting cable for the converter is supplied
by the Cable TV company.
Antenna
If your antenna has a round cable (75 ohm) on the end, then you're
ready to connect it to the TV.
If your antenna has flat, twin-lead wire (300 ohm), you first need
to attach the antenna wires to the screws on a 300 -to 75- ohm adapter.
Push the round end of the adapter (or antenna) onto the 75
(ohm) plug on the back of the TV.
If the round end of the antenna wire is threaded, screw it down finger
tight.
Verify that the On Screen Display (OSD) is set to Antenna.
Note: If your home has separate
UHF and VHF antennas, you will need a combiner to connect to the TV.
TV to
VCR
Follow the steps below to connect a basic antenna or Cable TV signal
to a VCR, and then the VCR to the TV. For information on other hookups
(possible when cable/ descrambler boxes are included), refer to the owner's
manuals for the VCR and the cable converter.
Connect your antenna or Cable TV signal to the IN FROM ANT (enna)
plug on the VCR.
Connect the OUT TO TV plug on the VCR to the 75 ohm plug on the TV
(connecting cable supplied with the VCR).
Refer to the owner's manual included with your VCR for other possible
connections and TV/VCR operating details.
Connecting to DVD/VCD/VCR/CATV BOX
Connect devices with cables provided. Select Composite or S-Video
input from On Screen Display (OSD) Menu. Refer to the Controls and
Indicators section in this document for more information on the OSD.
S-Video Source generally yields better video performance than composite.
Connect device with cables provided. Select Component input from
OSD Menu. For optimal performance use YPbPr for HDTV formats.
Connecting A/V Outputs
1. The Composite output jacks on W1700 back cover provides the function
to record your favorite program through broadcast or cable TV.
2. Connect devices (VCR, Camcorder...) with cables provided. Select
TV input from OSD Menu.
CAUTION: Before
performing any of the setup procedures listed below, read and follow the safety
instructions.
(ohm) plug on
the TV. 
