The proper operation of the function requires a
computer with VESA® DPMS power management capabilities. When used with a computer
equipped with VESA® DPMS, the monitor is ENERGY STAR® compliant.
As an ENERGY STAR® Partner, Dell Inc. has determined that
this product meets the ENERGY STAR®guidelines for energy efficiency.
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received including
interference that may cause undesired operation.
Instructions to Users: This equipment complies with the
requirements of FCC (Federal Communication Commission) equipment provided that following
conditions are met.
Power cable: Shielded power cable must be used.
Video inputs: The input signal amplitude must not exceed the
specified level.
CAUTION: Changes
or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
We hereby declare, that all major safety requirements, concerning to
CE-Mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC),
Electromagnetic Compatibility Directives (89/336/EEC, 92/31/EEC) are
fulfilled, as laid out in the guidelines set down by the member states of
the EEC Commission.This declaration is valid for all samples that
are part of this declaration, which are manufactured according to the
production charts appendix.The standards relevant for the evaluation
of electrical safety & EMC requirements are as follows :
LVD : EN
60950:1997+A1+A2+A3+A4
EMC : EN 55024:1998,
EN55022:1998, EN61000-3-2, 3:1995
1. Certificate of
conformity / Test report issued by :
LVD : NEMKO, TUV
EMC :Sporton
International Inc.
2. Technical
documentation kept at :
Liteon Technology Corp.
which will be made available upon request. (Manufacturer)
This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus set out in the Radio Interference Regulations of
the Canadian Department of Communications.
Note that Canadian Department of Communications (DOC) regulations
provide, that changes or modifications not expressly approved by Dell Inc.
could void your authority to operate this equipment.
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe B respecte toutes les exigences
du Reglement sur le materiel brouilleur du Canada.
This equipment complies with the limits for a Class 2 digital device
(devices used in or adjacent to a residential environment) and conforms to the standards
for information technology equipment that are set by the Voluntary Control Council for
Interference for preventing radio frequency interference in residential areas.
The equipment should draw power from a socket with an attached
protection circuit (a three-prong socket). All equipment that works together (computer,
monitor, printer, and so on) should have the same power supply source.
The phasing conductor of the room's electrical installation should
have a reserve short-circuit protection device in the form of a fuse with a nominal value
no larger than 16 amperes (A).
To completely switch off the equipment, the power supply cable must
be removed from the power supply socket, which should be located near the equipment and
easily accessible.
A protection mark "B" confirms that the equipment is in
compliance with the protection usage requirements of standards PN-93/T-42107 and
PN-89/E-06251.
The following information is provided on the device(s) described in
this document in compliance with the requirements of the official Mexican standards (NOM)
Exporter:
Dell Inc.
One Dell Way
Round Rock, TX 78682
Importer:
Dell Computer de México,
Paseo de la Reforma 2620, 11th Floor Col. Lomas
Altas
Mexcio DF
CP
11950
Ship to:
Dell Computer de Mexico,
S.A. de C.V. al Cuidado de Kuehne & Nagel
de México S. de R.I., Avenida Soles No. 55
Col. Peñn de los BaÑs, 15520 Mexico, D.F.
Supply voltage:
> 100/240 VAC
Frequency:
50/60 Hz
Current consumption:
1.2 A
Información para NOM (únicamente para México)
La información siguiente se proporciona en el dispositivo o en los
dispositivos descritos en este documento, en cumplimiento con los requisitos de la Norma
Oficial Mexicana (NOM):
Exporter:
Dell Inc.
One Dell Way
Round Rock, TX 78682
Importador:
Dell Computer de México, Paseo de la Reforma 2620,
11th Floor Col. Lomas Altas Méxcio DF CP
11950
Embarcar a:
Dell Computer de México,
S.A. de C.V. al Cuidado de Kuehne & Nagel
de México S. de R.I., Avenida Soles No. 55
Col. Peñon de los Baños, 15520 México, D.F.
You have just purchased a TCO'99 approved and labeled product! Your
choice has provided you with a product developed for professional use. Your
purchase has also contributed to reducing the burden on the environment and
also to the further development of environmentally adapted electronics
products.
Why do we have environmentally labeled computers?
In many countries, environmental labeling has become an established
method for encouraging the adaptation of goods and services to the
environment. The main problem, as far as computers and other electronics
equipment are concerned, is that environmentally harmful substances are used
both in the products and during their manufacture. Since it is not so far
possible to satisfactorily recycle the majority of electronics equipment,
most of these potentially damaging substances sooner or later enter nature.
There are also other characteristics of a computer, such as energy
consumption levels, that are important from the viewpoints of both the work
(internal) and natural (external) environments. Since all methods of
electricity generation have a negative effect on the environment (e.g.
acidic and climate-influencing emissions, radioactive waste), it is vital to
save energy. Electronics equipment in offices is often left running
continuously and thereby consumes a lot of energy.
What does labeling involve?
This product meets the requirements for the TCO'99 scheme which provides
for international and environmental labeling of personal computers. The
labeling scheme was developed as a joint effort by the TCO (The Swedish
Confederation of Professional Employees), Svenska Naturskyddsforeningen (The
Swedish Society for Nature Conservation) and Statens Energimyndighet (The
Swedish National Energy Administration).
Approval requirements cover a wide range of issues: environment,
ergonomics, usability, emission of electric and magnetic fields, energy
consumption and electrical and fire safety.
The environmental demands impose restrictions on the presence and use of
heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and
chlorinated solvents, among other things. The product must be prepared for
recycling and the manufacturer is obliged to have an environmental policy
which must be adhered to in each country where the company implements its
operational policy.
The energy requirements include a demand that the computer and/or
display, after a certain period of inactivity, shall reduce its power
consumption to a lower level in one or more stages. The length of time to
reactivate the computer shall be reasonable for the user.
Labeled products must meet strict environmental demands, for example, in
respect of the reduction of electric and magnetic fields, physical and
visual ergonomics and good usability.
Below you will find a brief summary of the environmental requirements met
by this product. The complete environmental criteria document may be ordered
from:
TCO Development
SE-114 94 Stockholm, Sweden
Fax: +46 8 782 92 07
Email (Internet): development@tco.se
Current information regarding TCO'99 approved and labeled products may
also be obtained via the Internet, using the address: http://www.tco-info.com/
Environmental requirements
Flame retardants
Flame retardants are present in printed circuit boards, cables, wires,
casings and housings. Their purpose is to prevent, or at least to delay the
spread of fire. Up to 30% of the plastic in a computer casing can consist of
flame retardant substances. Most flame retardants contain bromine or
chloride, and those flame retardants are chemically related to another group
of environmental toxins, PCBs. Both the flame retardants containing bromine
or chloride and the PCBs are suspected of giving rise to severe health
effects, including reproductive damage in fish-eating birds and mammals, due
to the bio-accumulative* processes. Flame retardants have been
found in human blood and researchers fear that disturbances in foetus
development may occur.
The relevant TCO'99 demand requires that plastic components weighing more
than 25 grams must not contain flame retardants with organically bound
bromine or chlorine. Flame retardants are allowed in the printed circuit
boards since no substitutes are available.
Cadmium**
Cadmium is present in rechargeable batteries and in the colour-generating
layers of certain computer displays. Cadmium damages the nervous system and
is toxic in high doses. The relevant TCO'99 requirement states that
batteries, the colour-generating layers of display screens and the
electrical or electronics components must not contain any cadmium.
Mercury**
Mercury is sometimes found in batteries, relays and switches. It damages
the nervous system and is toxic in high doses. The relevant TCO'99
requirement states that batteries may not contain any mercury. It also
demands that mercury is not present in any of the electrical or electronics
components associated with the labelled unit. There is however one
exception. Mercury is, for the time being, permitted in the back light
system of flat panel monitors as there today is no commercially available
alternative. TCO aims on removing this exception when a mercury free
alternative is available.
CFCs (freons)
The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be
used during the manufacture and assembly of the product. CFCs (freons) are
sometimes used for washing printed circuit boards. CFCs break down ozone and
thereby damage the ozone layer in the stratosphere, causing increased
reception on earth of ultraviolet light with e.g. increased risks of skin
cancer (malignant melanoma) as a consequence.
Lead**
Lead can be found in picture tubes, display screens, solders and
capacitors. Lead damages the nervous system and in higher doses, causes lead
poisoning. The relevant TCO?9 requirement permits the inclusion of lead
since no replacement has yet been developed.
*Bio-accumulative is defined as substances which
accumulate within living organisms
**Lead, Cadmium and Mercury are heavy metals which are
Bio-accumulative.
*Offers subject to change. Taxes, shipping, handling and other fees apply. U.S. Dell Small Business new purchases only. LIMIT 5 DISCOUNTED OR PROMOTIONAL ITEMS PER CUSTOMER. LIMIT 5 VOSTRO OR INSPIRON UNITS PER CUSTOMER. Dell reserves right to cancel orders arising from pricing or other errors.
